Reef Brite APEX Single or Dual Channel LED Interface

APEX-Certified versatile dimming control for Lumi Lite, Lumi Lite PRO, and XHO® lighting units.

​Easy to install and set up. Simply plug the interface inline between any Reef Brite LED unit and power supply, then plug the RJ45 cable into any available VR port on your APEX system. A VDM module is not required so long as you have a VR port available on the main APEX unit. Recommended maximum load for single or dual channel models is 120 watts per channel.

Quick start instructions basic set up:

• The interface plugs in between the XHO/Lumi Lite/Lumi Lite PRO LED Fixture and the power supply.
• Connect the RJ45 to any available VR port.
• Go to Fusion dashboard and locate your VR ports. Select ON on each VR port one at a time until you see the Reef Brite lights come on. These will be the VR ports to access the ramping and ON/OFF functions.
• Go to the settings on the VR port(s) assigned to the Reef Brite Lights and select Basic settings.
• Select device (select the Icon that looks like a Light Bulb).
• From there, use the set points on the screen to determine when you want the lights to turn ON/OFF and the desired intensity levels. Tip: the easiest way to set it up is to use three set points.
• Set the first set point for the time you would like the light(s) to come on (Set to 0%).
• Set the second set point for the time you want the light(s) at maximum intensity (Set from 0-100%).
• Set the third set point for the time you want the light(s) to turn off (Set to 0%).
• Make sure to save your settings and you are all set.
• Your Reef Brite units will now automatically turn ON/OFF and ramp up and down.

​IMPORTANT NOTICE:
When installing any lighting product, power supply, or controller, do not install in
a manner that will allow any part or component to come in direct contact with water.
Reef Brite assumes no liability for incorrectly installed products.